Instructions for Installing Your Generation 3 V2 Jaws for 3/16" Blades

Instructions for Installing Your Generation 3 V2 Jaws for 3/16" Blades



To install your new 3/16" Jaws on your CamLock Vise you will need your depth key and you will need to move your vise lever to the upright, unlocked position. Your tension adjust should be at the lowest setting possible.

REMOVING JAWS:  Pinch the Jaws together with two fingers and use a single pin of the depth key to push the pins holding the vice jaw out the front of the sharpener. Now remove these pins and set them aside and then remove the Jaws. Be sure to keep them pinched together as there's a spring inside that can easily be lost.

INSTALLING JAWS: Take your new Jaws and slide them into the vacant spot in the Vise and reinsert the pins. They can be reinserted through the front of the back of the vise. You will need to line the pins up with the hole through the jaw and the polyurethane spring, which can take some fiddling until it slides in easily.

    • Related Articles

    • Instructions for Installing Your Generation 3 V2 Upgrade Jaws for 1/4" Blades

      Instructions for Installing Your Generation 3 V2 Upgrade Jaws for 1/4" Blades. These jaws are designed to work with the Cam-Lock Vise. If you have a Generation 3 Pro, WE130 or have upgraded another model to have the Cam-Lock Vise, these jaws will fit ...
    • Instructions for Installing Your DualCam© Vise Jaws for 1/4" Blades

      To install the DualCam© Vise Jaws for 1/4" Blades you will need your depth key and to ensure that your vise lever is in the upright position so the Jaws are open. REMOVING JAWS: Pinch the current installed jaws together with thumb and forefinger ...
    • How to Install Your Generation 3 Jaws for 1/4" Blades

      To change out the Jaws on your Wicked Edge Generation 3 Cam-Lock Vise, simply remove the standard jaws by removing the pins that hold them in place, as shown in the  image. (Make sure your vise is in the open position when you remove the pins.) You ...
    • How to Install Your Generation 3 Jaws for 1/4" Blades

      To install your new jaws, simply remove your standard jaws by removing the pins that hold them in place. (Sometimes they can be stiff, especially after a lot of sharpening. You may need to use a mallet and tap to remove them.) When the jaws are ...
    • Generation 4 Pro Sharpener Instructions for Set Up and Use

      The following playlist will help you set up and use your Generation 4 Pro sharpener Included Items & Setup for the Generation 4 Pro Micro Angle Adjusts on the generation 4 Pro (optional) Vise Operation and Starting Blade Position on the Generation 4 ...